HPE Community
Comware Based
1753512 Members
5640 Online
108795 Solutions
New Discussion

Re: Issues With Bridge-Aggregation and Trunking

 
L1nklight
Valued Contributor

‎05-13-2015 11:05 AM

‎05-13-2015 11:05 AM

Issues With Bridge-Aggregation and Trunking

I have a UCS installation that I am performing right now. I am working with a set of HP 5800s. I have setup a bridge-aggregate group and I seem to be running into a problem where only one of my blades is available out of the ones I have setup. I can successfully ping one of my blades from my core network system however the other two appear to be unavailable. When I do a display mac-add I only see the available blade in the mac-address table. When I do a display arp I only see the one available blade server bound to the bridge aggregate group. 

 

Any ideas? 

0 Kudos
1 REPLY 1
L1nklight
Valued Contributor

‎05-13-2015 02:46 PM

‎05-13-2015 02:46 PM

Re: Issues With Bridge-Aggregation and Trunking

Issue is resolved. We were non specific on where the virtualized nics from the UCS system were pointed to. We ended up blackholing internal network traffic to a pair of LACP interfaces used for DMZ traffic. In the UCS system we had to specify which ports were pinned to the internal LACP interfaces and which ports were pinned to the dmz based LACP interfaces. 

 

Issue is resolved. 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.