- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: LACP for 12 Port
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-11-2018 02:21 AM
06-11-2018 02:21 AM
LACP for 12 Port
Hi,
I have Two HP 5940 switch running in IRF,
I used one Aruba 2930F as L2.
I need to configure 6 ports as LACP from switch-1 and 6 ports from switch-2 in one group.
Since only 8 port is possible to configure LACP, I need to make 4 links as redundance. if i remove 2 links from each switch.
Is it possible to configure 12 ports in one LACP group...?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2018 06:50 AM
06-14-2018 06:50 AM
Re: LACP for 12 Port
you should be able to
-On 5940 switch set the maximum number of selected ports to 8
[HP-Bridge-Aggregation2]link-aggregation selected-port maximum ? INTEGER<1-32> Specify the maximum number [HP-Bridge-Aggregation2]link-aggregation selected-port maximum 8
and then assign 12 physical ports to your bridge aggregation group as per usual procedure
I'm not sure about aruba but if it runs comware I guess same steps would apply
check this out aswell:
https://support.hpe.com/hpsc/doc/public/display?docId=c05212329