- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: Link Aggregation on HP running IRF
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО07-17-2018 11:30 AM
тАО07-17-2018 11:30 AM
Hi!
I need some information which I cannot find on some website.
If I am running IRF on HPE FlexFabric and I want to create Link Aggregation from new switch which is not part of the network then I will connect one cable to Primary HP and one cable to secondry and as they are running IRF then I can see ports 48 on primary one as the secondry one is synced with it.
So I will create link aggregation on both HP (What I mean is first half of HP is 24 ports so I create settings for link aggregation on port 20 and will take the port 20 which is 2/20 and so the same config)
Hope I define it fine :)
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО07-17-2018 11:06 PM
тАО07-17-2018 11:06 PM
SolutionFirst: don't connect cabling before port trunking (link aggregations, on both peers: the IRF and the 3rd Switch involved) are configured...that's to avoid loops.
Then: configure LAG both on IRF and on your 3rd involved Switch; on IRF the LAG configuration is the same you apply on your 3rd Switch (considering you're dealing with all Comware operating system based units...LAG on ProCurve/ArubaOS-Switch operating system based units has configuration CLI commands slightly different)...just the port numbering is different since you are dealing with 2 Switches in a IRF domain.
Once done connect one cable at time (IRF Member 1 Interface 1 to 3rd Switch Interface 1, IRF Member 2 Interface 1 to 3rd Switch Interface 2)...using the interfaces numbers you really have planned to use.
I'm not an HPE Employee
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО07-20-2018 12:47 AM
тАО07-20-2018 12:47 AM
Re: Link Aggregation on HP running IRF
Thanks