- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: NPS RADIUS
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО12-08-2016 02:38 PM - edited тАО12-09-2016 05:53 AM
тАО12-08-2016 02:38 PM - edited тАО12-09-2016 05:53 AM
Hello I am trying to setup my HP A5500-48G-4SFP HI IRF with 2012 R2 NPS RADIUS authentication, but I get "Access Denied" message while trying to login to switch. I enabled debugging and attachment is a file that I copied from the output of the debugging. The config of my NPS server is also attached. My Comware version is 5.20.99
Any help will be highly appreciated.
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО12-15-2016 08:11 AM
тАО12-15-2016 08:11 AM
SolutionOK, so finally I was able to resolve this issue by adding vendor attributes into my NPS server.
First I added the sending attributes into RADIUS server by copying them from HP debugging outputs and one more attribute was added to give the domain logged on user privilege 3.
Unfortunately HP does not have great documents about these new features and changes in its Comware operating system.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО03-06-2019 07:57 AM
тАО03-06-2019 07:57 AM
Re: NPS RADIUS
Hello
I have the same problem. Can be much detail... What attributes did you add?
Thanks.