HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Please help me convert these two lines to comware

 
totalnewbie
Occasional Contributor

Please help me convert these two lines to comware

Hi Everyone

 

Im trying to convert rspan on a cisco catos switch to an H3c 7506 switch and im just getting a little confused. Can anyone help me convert the below to comware please?

 

set rspan source 2,5-9,25 800 both multicast enable create

set rspan destination  3/14  800  inpkts disable learning enable create

 

Im confused on how to go about converting it especially the commands such as "inpkts"

 

Any help would be appreciated.

 

Thanks

 

 

5 REPLIES
totalnewbie
Occasional Contributor

Re: Please help me convert these two lines to comware

Anyone??? im really struggling here :(

James-W
Occasional Advisor

Re: Please help me convert these two lines to comware

The attached doc gives you monitor session commands to Commware & Pro-curve kit, so this should be adaptable to Cat OS.

totalnewbie
Occasional Contributor

Re: Please help me convert these two lines to comware

Hi James

 

Thanks for this, but this is for mirroring ports. I think I can do that, however im having a problem mirroring multiple vlans. When I try the mirroring command I cant enter the vlan, just a physical port number.

James-W
Occasional Advisor

Re: Please help me convert these two lines to comware

Hi, Not sure if this helps you -

 

Syntax

mirroring-group group-id remote-probe vlan remote-probe-vlan-id

undo mirroring-group group-id remote-probe vlan remote-probe-vlan-id

View

System view

Parameters

group-id: Group number of a port mirroring group, in the range of 1 to 20.

remote-probe vlan remote-probe-vlan-id: Specifies the remote-probe VLAN for the mirroring group.

Description

Use the mirroring-group remote-probe vlan command to specify the remote-probe VLAN for a mirroring group.

Use the undo mirroring-group remote-probe vlan command to remove the configuration of remote-probe VLAN for a mirroring group.

Examples

# Configure VLAN 100 as the remote-probe VLAN.

<H3C> system-view

System View: return to User View with Ctrl+Z.

[H3C] mirroring-group 1 remote-probe vlan 100

 

http://www.h3c.com/portal/Technical_Support___Documents/Technical_Documents/Switches/H3C_S7500_Series_Switches/Command/Command/H3C_S7500_CM-(Release_3100_Series)-(V1.04)/200707/207793_1285_0.htm#_Toc172456395

totalnewbie
Occasional Contributor

Re: Please help me convert these two lines to comware

Hi

 

Thanks for that.

 

Correct me if im wrong but I thought a probe vlan simply outputs the specified mirrored ports right? So for example packets from ports gig 1,2,3 are mirrored to a probe vlan and then you use an analyzer to that vlan in order to collect the data?

 

My aim is to analyze data from multiple vlans and I cant do it like I can on cisco switches.