- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Portsecurity Multiple MAC and Ports
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-24-2016 04:16 AM - edited 11-25-2016 03:42 AM
11-24-2016 04:16 AM - edited 11-25-2016 03:42 AM
Portsecurity Multiple MAC and Ports
Dear,
We have mobile equipment that can be connected in different rooms. We would like to secure the outlets that only those devices can be connected. When we set port-security on the first port the config is accepted. When we set the config on the seconds port we receive the error that the mac-address is already in use. We need to configure the same mac-addresses on all those ports because the equipment can be switched between the rooms. Is it possible to configure same mac addressen on multiple ports for port security? Switch Type: HP 5500 Comware Version 5.20.99. Hereby the config we tested with.
interface GigabitEthernet1/0/32
port link-mode bridge
port link-type hybrid
port hybrid vlan 1 untagged
poe enable
stp edged-port enable
port-security max-mac-count 4
port-security port-mode autolearn
port-security intrusion-mode blockmac
port-security mac-address security xxxx-xxxx-xxxx vlan 1
port-security mac-address security xxxx-xxxx-xxxx vlan 1
port-security mac-address security xxxx-xxxx-xxxx vlan 1
port-security mac-address security xxxx-xxxx-xxxx vlan 1
Kind Regards, Wim