Comware Based
1748244 Members
3784 Online
108760 Solutions
New Discussion

Portsecurity Multiple MAC and Ports

 
WimV
Occasional Advisor

Portsecurity Multiple MAC and Ports

 

Dear,

We have mobile equipment that can be connected in different rooms. We would like to secure the outlets that only those devices can be connected. When we set port-security on the first port the config is accepted. When we set the config on the seconds port we receive the error that the mac-address is already in use. We need to configure the same mac-addresses on all those ports because the equipment can be switched between the rooms. Is it possible to configure same mac addressen on multiple ports for port security? Switch Type: HP 5500 Comware Version 5.20.99. Hereby the config we tested with.

 interface GigabitEthernet1/0/32
port link-mode bridge
port link-type hybrid
port hybrid vlan 1 untagged
poe enable
stp edged-port enable
port-security max-mac-count 4
port-security port-mode autolearn
port-security intrusion-mode blockmac
port-security mac-address security xxxx-xxxx-xxxx vlan 1
port-security mac-address security xxxx-xxxx-xxxx vlan 1
port-security mac-address security xxxx-xxxx-xxxx vlan 1
port-security mac-address security xxxx-xxxx-xxxx vlan 1

Kind Regards, Wim