Problem - HP A7510 with IRF

[Jonucas]

I have error and cannot put the command in the second switch for IRF.

irf member 1 renumber 2

in all the time the log is showing error

Error: The device is not in the current IRF

any idea ?

[pombeii]

Perform the display irf topology command to make sure that you have assigned IRF member ID 1 in the IRF fabric.

[Jonucas]

Configuration IRF is very easy but the problem is firmware , I did upgrade and I got other error.

I contact HP support and they will be doing lab to identify the problem....

[Malou]

IRF on A7500 with unit number 2 doesn't work use unit 3 : irf member 1 renumber 3

moreover the swith must be in irf mode (command chassis convert mode irf)

[Jonucas]

Who is writting this reply ?

I configured it but the configuration guide said other thing ( member 1 and member 2 , not memebr 3 ) . I fixed myself .If you are working with HP , 3COM, H3C  I have question for you.

Where is the member 2 ?

In the configuration of both switches with IRF is showing  chassis 1 and chassis 3 . where is chassis 2 ?  H3C ( HP must fixed that issue with firmware )

JN

[Jonucas]

Check:

H3C S7500E Series Ethernet Switches IRF Configuration Guide

( Software version: S7500E Series--Release 6626 and Later )

[TJtheone]

Hi

as per my understating it gives that error massage because the 2nd switch was not 1 it numbers as another number so u have to check the irfmember number of the 2nd switch after that u need to issue a command

irf member "X" renumber 2  

where the X is the member number of the 2nd switch.

if there are 3 switches need to be IRF the master will 1 and the other two swiches will 2 and 3 by default it mark as 1 that is the one u need to me renumber as the required number

[Jonucas]

Hi,

Thanks for suggestion but first you must read the information because I am writting about HP A7510 ( H3C S7510E).

They only support 2 switches for IRF.

HP ( H3C ) must fix that issues.

JN