Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem when enabling PoE on 5130-48G-PoE+-4SFP+ (370W) EI JG937A

 
Karima1
Occasional Contributor

Problem when enabling PoE on 5130-48G-PoE+-4SFP+ (370W) EI JG937A

Hello,

I have an IRF 2 fabric (HP 5130-48G-PoE+-4SFP+ (370W) EI JG937A switch), and I have this error when enabiling Poe on the second switch :

PSE or power source not ready. Check for loose DIMM connection or PSE firmware corruption and verify that the power source has been turned on.

I played this command :

#disp poe device
Slot 1:
PSE ID Slot No. SSlot No. PortNum MaxPower(W) State Model
4             1     0              48                370.0                On    LSP7POEB
Slot 2:
PSE ID Slot No. SSlot No. PortNum MaxPower(W) State Model
7            2      0              48                370.0               Off     LSP7POEB

# disp poe pse 7
PSE ID : 7
Slot No. : 2
SSlot No. : 0
PSE Model : LSP7POEB
PSE Status : Enabled
Power Priority : Low
Current Power : 0.0 W
Average Power : 0.0 W
Peak Power : 0.0 W
Max Power : 370.0 W
Remaining Guaranteed Power : 370.0 W
PSE CPLD Version : -
PSE Software Version : 0
PSE Hardware Version : 0
Legacy PD Detection : Disabled
Power Utilization Threshold : 80
PD Power Policy : Disabled
PD Disconnect-Detection Mode : DC

Is it normal to have PSE Software Version =0?

I've just updated the Switch firmware, I'm currently running the 3208P16 release and I rebooted the switch but I still have the same problem.

Any ideas ? 

Thanks.

2 REPLIES 2
Highlighted
Emil_Gogushev
Respected Contributor

Re: Problem when enabling PoE on 5130-48G-PoE+-4SFP+ (370W) EI JG937A

Hello, 

Оn the download page, in section Other you can find the PoE firmware file 5130-1950_POE-145

 

https://h10145.www1.hpe.com/downloads/SoftwareReleases.aspx?ProductNumber=JG937A

The Release Notes, Appendix A upgrading firmware has instruction on how to update the PoE firmware.

https://support.hpe.com/hpsc/doc/public/display?docId=c04796798

Maybe you could try to update the PoE using the full option. 

Emil Gogushev /HPE
Karima1
Occasional Contributor

Re: Problem when enabling PoE on 5130-48G-PoE+-4SFP+ (370W) EI JG937A

Hello,

I got Update error when I tried these commande :

poe update full 5130EI_1950-POE-145.bin pse 7

poe update refresh 5130EI_1950-POE-145.bin pse 7

 

Any idea why I got this error ?