Problem with 3com Baseline 2928-HPWR Plus WebUI

[Danielll]

Hello!

New to the forum, hope I can get help here.

I recently purchased a used 3com Baseline Switch 2928-HPWR Plus 24 but upon accessing the webUI I seem to have a lot of blank unusable pages, I'm using chrome/internet explorer.

There is only a few usable pages on the webUI, not too sure how to access via telnet/ssh, or if there's updates for the firmware/software

Love some advise.

P.S. This thread ahs been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Comware-Based. - Hp Forum Moderator

[sdide]

Hi,

I think the 3com 2900 series  resembles the HP1910 series. the

3com 2928-HPWR specifically matches the 1910-24G-PoE (365W) Switch (JE007A).

It should run comware 5, and you should be able to access the console configure it from there 

(enable the telnet- or ssh-server, to what fits you the best)

below is a link to the comware release 1103 manual, not sure what release your 3com runs)

http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c03941555-2.pdf

Regards