Comware Based
1752567 Members
4947 Online
108788 Solutions
New Discussion юеВ

Redirection support on HP5130 switch

 
SOLVED
Go to solution
Dinesh4
Occasional Advisor

Redirection support on HP5130 switch

Hi Everyone,

I am looking for information on supoprt for URL redirection for HP 5130 switches.
The following model is being used in our environment:

HPE Comware Software, Version 7.1.070, Release 3208P03
Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP
HPE 5130 48G PoE+ 4SFP+ EI Switch uptime is 7 weeks, 1 day, 15 hours, 18 minutes
Last reboot reason : User reboot

Boot image: flash:/5130ei-cmw710-boot-r3208p03.bin
Boot image version: 7.1.070, Release 3208P03
Compiled Dec 14 2017 18:00:00
System image: flash:/5130ei-cmw710-system-r3208p03.bin
System image version: 7.1.070, Release 3208P03
Compiled Dec 14 2017 18:00:00

Slot 1:
Uptime is 7 weeks,1 day,15 hours,18 minutes
5130-48G-PoE+-4SFP+ (370W) EI JG937A with 1 Processor
BOARD TYPE: 5130-48G-PoE+-4SFP+ (370W) EI JG937A
DRAM: 1024M bytes
FLASH: 512M bytes
PCB 1 Version: VER.B
Bootrom Version: 147
CPLD 1 Version: 002
Release Version: HPE 5130 48G PoE+ 4SFP+ EI JG937A-3208P03
Patch Version : None
Reboot Cause : UserReboot
[SubSlot 0] 48GE+4SFP Plus

Any pointers, if this is supported?
If supported, are there configuration documents that you could point to?

Thank you,

3 REPLIES 3
akg7
HPE Pro

Re: Redirection support on HP5130 switch

Hi,

 

This is feature is supported.

Kindly refer below link for the configuration guide:

 

http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-a00007093en_us-1.pdf

 

 

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo
Dinesh4
Occasional Advisor
Solution

Re: Redirection support on HP5130 switch

I was able to get the redirection working with Cisco ISE.
The issue was the way ACL was configured earlier, had to tweak the ACL in the following way to get the redirection page forwarded to ISE.
sample ACL that I used:

rule 0 permit udp destination-port eq bootps
rule 5 permit udp destination-port eq bootpc
rule 10 permit udp destination-port eq dns
rule 15 permit ip destination <Cisco ISE Server> 0

Dinesh4
Occasional Advisor

Re: Redirection support on HP5130 switch

There is one more update from Cisco, that dynamic redirectin is not supported with H3C devices. 

The solution to allow redirection to work with Cisco ISE and other NAD that do not support redirection, Cisco's Auth VLAN feature could be utlized.

The issue has been reported as a bug as of now here: Bug - CSCvn03432