HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

S3600 copy configuration command

 
irfank
Occasional Contributor

S3600 copy configuration command

Hello,

 

I need to copy the certain port configurations from one port to all the others. The "copy configuration" command did not work, since it doesn´t copy the "broadcast-suppression pps 3000" and "undo jumboframe enable" configuration settings.

Any idea how I can do this, without having to configure every single port?

 

Regards,

 

Irfan Keskin



 

6 REPLIES
peyushzach
Frequent Advisor

Re: S3600 copy configuration command

just select all the ports together and run the command

eg :

if you have to copy it on ports 1 to 48

 

9HSW-2(config)# interface 1-48
 

and then type in the command ..it will apply for all those selected ports.

 

thanks

irfank
Occasional Contributor

Re: S3600 copy configuration command

This switch is an HP A-Series switch and runs comware operating system. Your commands does not count here.  :)

pombeii
Frequent Advisor

Re: S3600 copy configuration command

Assign the ports to a port group to bulk configure the two commands that cannot copy between ports.

<Sysname> system-view

[Sysname] port-group manual group1

[Sysname-port-group-manual-group1] group-member interface-list

[[Sysname-port-group-manual-group1] broadcast-suppression 20

irfank
Occasional Contributor

Re: S3600 copy configuration command

Hello Pombeii,

 

I think this config will work and have transferred this information to the customer. I will wait for their response and let you know.

 

Best regards,

 

Irfan

irfank
Occasional Contributor

Re: S3600 copy configuration command

Hello,

 

Our customer runs  s36si_e-cmw310-r1702p30-s168.bin  software on their switches. They have informed me that, there is no port-group command opportunity in the System-view context of the switch. Please advise.

 

BR,

 

Irfan

irfank
Occasional Contributor

Re: S3600 copy configuration command

Any comment?   :)