Schedule a NQA operation

[ksvicky]

HI All,

I have configured NQA with UDP Jitter, when im trying to shedule the opration getting error on recurring value

if any one knows share it / advice how to start the jitter opration

[HPE]nqa schedule admin test start-time now lifetime forever
Incomplete NQA operation parameters. Can't start the NQA operation.
[HPE]nqa schedule admin test start-time now lifetime forever ?
recurring Run the operation automatically at the start time and for the
specified duration
<cr>

[HPE]nqa schedule admin test start-time now lifetime forever recu
[HPE]nqa schedule admin test start-time now lifetime forever recurring ?
<cr>

[HPE]nqa schedule admin test start-time now lifetime forever recurring 01
^
% Too many parameters found at '^' position.
[HPE]

[HPE]

[Giri12 · Accepted solution]

Please post full nqa configuration & firmware version.

Schedule cannot be forever & recurring

Example:

Firmware :  

7.1.045, Release 1120P10

#

nqa entry admin 1

type udp-jitter

  destination ip 1.1.1.1

  destination port 9000

#

nqa schedule admin 1 start-time now lifetime forever

#

[ksvicky]

Thanks for the details i was trying without port and now i have schduled the operation ..

how to stop the schduled operation  ?  

# 

Firmware : Version 7.1.045, Release 3113P05

nqa configuration 

#
nqa entry admin test
type udp-jitter
destination ip 172.16.2.27
destination port 9000

#

nqa schedule admin test start-time now lifetime forever

#

[Giri12]

Hello Vicky

Do the undo command to stop the schedule

#

undo nqa schedule admin test start-time now lifetime forever

#

Hope it helps!!!