- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: Switch fallback configuration after an false c...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-25-2013 01:56 AM - last edited on тАО09-21-2014 05:10 PM by Lisa198503
тАО11-25-2013 01:56 AM - last edited on тАО09-21-2014 05:10 PM by Lisa198503
Switch fallback configuration after an false command
Switch fallback configuration after an error
Hi,
when i put an false command from remotely and because of this I lost the the link to the switch. It is possible the device reset automaticly my command?
Regards Andreas
P.S. This thread has been moved from ProCurve / ProVision-Based to Comware-Based. -HP Forum Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-25-2013 05:04 PM
тАО11-25-2013 05:04 PM
Re: Switch fallback configuration after an false command
Yes, before issuing the false command, you issue the "reload in 5" command and it will reload itself into its saved config 5 minutes afterwards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-25-2013 05:30 PM
тАО11-25-2013 05:30 PM
Re: Switch fallback configuration after an false command
many thanks, but it's only for procurve switches right? I have HP (H3C) 5120, 5500, 5800 EI.
Regards Andreas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-26-2013 02:42 PM
тАО11-26-2013 02:42 PM
Re: Switch fallback configuration after an false command
"schedule reboot delay 5"