Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Tagged/Untagged whoas (I think)

justanotheruser_1
Occasional Visitor

Tagged/Untagged whoas (I think)

So here is the run down.



I've got 3 4500G switches, all interconnected.  Multiple vlans.



The issue is, that the switch that I'm current connected to (sw02), port G1/0/2.  I can connect the main switch (sw01) which is on vlan 7 and vlan 114.  Both have IP addresses.  However, sw02 just has an IP address on vlan 114.



I cannot ping/telnet into sw02 without first remoting into sw01, and then back to sw02.



I have the pvid set to vlan 7, and I have vlan 7 tagged and vlan 114 untagged.



I know this is kinda vague.  But, please ask me what information you need, and I'll be happy to answer you.  This is just very frustrating me.  Thank you in advance!!!

1 REPLY
justanotheruser_1
Occasional Visitor

Re: Tagged/Untagged whoas (I think)

So here is the run down.



I've got 3 4500G switches, all interconnected.  Multiple vlans.



The issue is, that the switch that I'm current connected to (sw02), port G1/0/2.  I can connect the main switch (sw01) which is on vlan 7 and vlan 114.  Both have IP addresses.  However, sw02 just has an IP address on vlan 114.



I cannot ping/telnet into sw02 without first remoting into sw01, and then back to sw02.



I have the pvid set to vlan 7, and I have vlan 7 tagged and vlan 114 untagged.



I know this is kinda vague.  But, please ask me what information you need, and I'll be happy to answer you.  This is just very frustrating me.  Thank you in advance!!!