- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Trunk between 4800G and 4500G goes down
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-08-2011 04:14 AM
03-08-2011 04:14 AM
When I try to setup a trunk with aggregation between a 4500G and 4800G, the trunk goes down. Below are the configuration of both switches.
4500G
inter bridge aggregation 1
link-aggregation mode dynamic
description trunk 4500-4800
interface giga 1/0/49
port link-aggregation group 1
port link-type trunk
port trunk permit vlan all
interface giga 1/0/50
port link-aggregation group 1
port link-type trunk
port trunk permit vlan all
4800G
link-aggregation load-sharing mode destination-mac source-mac
inter bridge aggregation 2
description trunk 4800-4500
interface giga 1/0/49
port link-aggregation group 2
port link-type trunk
port trunk permit vlan all
interface giga 2/0/49
port link-aggregation group 2
port link-type trunk
port trunk permit vlan all
I modified the 4800 configuration of the bridge to dynamic mode without success...
Any suggestion will be welcome
Regards, Hector
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2011 08:47 AM
03-09-2011 08:47 AM
Solutionhi ducheus
You have to configure the trunk on the bridge-aggregation. Else there is a missmatch between the bridge interface and the physical interface and the bridge will not come up.
and sync the LACP-mode. remove or add the dynamic on both switches.
br
Manuel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2011 08:36 AM
03-14-2011 08:36 AM
Re: Trunk between 4800G and 4500G goes down
Problem solved! Thanks a lot.