Unable to adjust behavior settings in 2928 UI

[Tamas Gregorics]

Hi,

I have a 2928 switch and i want to set up some bandwidth limits on 2 of the ports. I created an ACL matching the IP adresses of the servers, then created a classifier, containing a rule matching the acl. Now i wanted to create a behavior rule, but all the rate limit settings are grayed out and inactive.

How can i enable them? I really have to limit 2 of my servers to 15 mbit (internet traffic).

[marcos]

If limiting the overall network data rate is all you want, I'd rather suggest configuring per-port limits. You can use the "Line Rate" menu item for this and set the ports to eg. 14912 kbps.

[Tamas Gregorics]

Unfortunately that is not an option, since then both of the ports would be allowed 15mbit and that is 30mbit in summ.

If i used 7.5mbit that would work, but then if one of the servers are idle, the other wastes the bandwidth.

And I can't control the gigabit uplink port, because that is a tagged vlan port, transporting both my internet and local lan data.