Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Unable to adjust behavior settings in 2928 UI

Tamas Gregorics
Occasional Advisor

Unable to adjust behavior settings in 2928 UI

Hi,



 



I have a 2928 switch and i want to set up some bandwidth limits on 2 of the ports. I created an ACL matching the IP adresses of the servers, then created a classifier, containing a rule matching the acl. Now i wanted to create a behavior rule, but all the rate limit settings are grayed out and inactive.



 



How can i enable them? I really have to limit 2 of my servers to 15 mbit (internet traffic).

2 REPLIES
marcos
Advisor

Re: Unable to adjust behavior settings in 2928 UI

If limiting the overall network data rate is all you want, I'd rather suggest configuring per-port limits. You can use the "Line Rate" menu item for this and set the ports to eg. 14912 kbps.



Tamas Gregorics
Occasional Advisor

Re: Unable to adjust behavior settings in 2928 UI

Unfortunately that is not an option, since then both of the ports would be allowed 15mbit and that is 30mbit in summ.



If i used 7.5mbit that would work, but then if one of the servers are idle, the other wastes the bandwidth.



And I can't control the gigabit uplink port, because that is a tagged vlan port, transporting both my internet and local lan data.