Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Unable to enable service-template-based client rate in MSR954

Artur_M
Occasional Contributor

Unable to enable service-template-based client rate in MSR954

Hello

According to "Comware 7 Wlan Configuration Guide" page 115/116 I'd like to set bandwidth to all my SSIDs.

Unfortunately there are no such commands in my box:

[HPE-WLAN-Radio0/0]bandwidth-guarantee enable
                   ^
 % Unrecognized command found at '^' position.
[HPE-WLAN-Radio0/0]client-rate-limit enable
                   ^
 % Unrecognized command found at '^' position.
[HPE-WLAN-Radio0/0]?
Wlan-radio interface view commands:
  a-mpdu                   Configure the aggregate MAC protocol data unit
                           function
  a-msdu                   Configure the aggregate MAC service data unit
                           function
  ani                      Adaptive Noise Immunity
  antenna                  Configure the antenna
  application              Specify an application
  aspf                     Advanced Stateful Packet Filter(ASPF) module
  attack-defense           Configure the attack defense function
  beacon-interval          Set the beacon interval
  blacklist                Configure the blacklist function
  cac                      Connect admission control
  cfd                      Connectivity Fault Detection (CFD) module
  channel                  Configure channel parameters
  channel-switch           Configure channel switching
  client                   Configure client parameters
  client-mode              Workgroup bridge client configuration
  client-proximity-sensor  Client probing configuration
  client-verify            Configure the client verification function
  connection-limit         Connection limit module
  continuous-mode          Enable the radio continuous mode
  custom-antenna           Configure the custom antenna
  default                  Restore the default settings

[...]
[HPE]dis cur
#
 version 7.1.064, Release 0605P20

Did I missed sth?

Regards

A.

2 REPLIES
Vince-Whirlwind
Honored Contributor

Re: Unable to enable service-template-based client rate in MSR954

The MSR954 manual doesn't have any radio bandwidth command except for defining the channel bandwidth of dot11n.

There is a client max-count n command.

 

Artur_M
Occasional Contributor

Re: Unable to enable service-template-based client rate in MSR954


@Vince-Whirlwindwrote:

The MSR954 manual doesn't have any radio bandwidth command except for defining the channel bandwidth of dot11n.

There is a client max-count n command.

 


Thank you for unclouding.

I'm disapointed with "HPE FlexNetwork MSR Router Series Comware 7 WLAN Configuration Guides" (Document version: 6W100-20160526). I found there: "WLAN is supported only on the MSR954(JH297A/JH298A/JH299A)" in "Feature and hardware compatibility" section. It is really misleading.

Regards

A.