Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Upgrade switch FlexFabric 5700-40XG-2QSFP+ JG896A

 
Occasional Visitor

Upgrade switch FlexFabric 5700-40XG-2QSFP+ JG896A

Hello, I have a customer with FlexFabric switch 5700-40XG-2QSFP + JG896A firmware version r2311p06 I would like to update them to version R2432P06 can I make a single jump to the new version or are there intermediate steps required?
Thank you very much

4 REPLIES 4
Highlighted
HPE Pro

Re: Upgrade switch FlexFabric 5700-40XG-2QSFP+ JG896A

If IRF is configured the update is disruptive.  There are hot fixes to P06 - consider installing H07 after updating using the boot-loader method to the switches and rebooting the domain.


I am a HPE Employee

Accept or Kudo


Highlighted
Occasional Visitor

Re: Upgrade switch FlexFabric 5700-40XG-2QSFP+ JG896A

Hy,

yes I have 4 chassis in irf.

Are there any problems to do this in irf?

I want reboot all switch in the same moment, I don't applicate issu method.

Highlighted
HPE Pro

Re: Upgrade switch FlexFabric 5700-40XG-2QSFP+ JG896A

Use the "boot-loader file flash:" to install the r2432p06  ipe on each slot and reboot the domain.

The release notes wrote : "Use the boot-loader command or the BootRom menu to upgrade the software from 23XX to
24XX, rather than using the issu command."


I am a HPE Employee

Accept or Kudo


Highlighted
HPE Pro

Re: Upgrade switch FlexFabric 5700-40XG-2QSFP+ JG896A

You don't necessarily have to IPE on each member.  If you do the boot-loader command on the master, you can tell it to install on all slots.  You would then only unpack the IPE once.

Just make sure that there is enough flash space on each member before you use the boot-loader command.

Regards,

David

I work for HPE

Accept or Kudo