HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect / 3Com swith VLAN passthrough

 
Alex_H1
Occasional Visitor

Virtual Connect / 3Com swith VLAN passthrough

Hi All,

 

I'm currently running two C3000 chassis's both connecting through virtual connect switches, these are both set to allow VLAN tunnelling. Both VC's connect to a 3COM 5500G but are not able to pass any VLAN information. 

 

Is there a CLI command on the 3COM to enable VLAN tunnelling so both blades can communicate.

 

I've found this command 'port trunk permit vlan all' , would this be suitable?

 

Many thanks

Alex