Skip to ContentSkip to Footer
Start of content
- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: Vlan 4800G 24-port
Comware Based
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Latin America
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
09-02-2009 01:08 AM
09-02-2009 01:08 AM
Vlan 4800G 24-port
I set regular vlan.But I get line protocol and interface current state Down.
Vlan-interface11 current state: DOWN
Line protocol current state:DOWN
Description: NT
The Maximum Transmit Unit is 1500
Internet Address is 10.4.11.254/24 Primary
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0020-9c6b-a72b
IPv6 Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0020-9c6b-a72b
I can’t get what its wrong.
Vlan-interface11 current state: DOWN
Line protocol current state:DOWN
Description: NT
The Maximum Transmit Unit is 1500
Internet Address is 10.4.11.254/24 Primary
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0020-9c6b-a72b
IPv6 Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0020-9c6b-a72b
I can’t get what its wrong.
3 REPLIES 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
09-02-2009 03:51 PM
09-02-2009 03:51 PM
Re: Vlan 4800G 24-port
Is there any host connected to the switch using the VLAN 11? Is there a trunk port that permits the traffic passing of VLAN 11? If there's no host connected to a port using the VLAN 11 or trunk ports up with the VLAN 11 permitted, the interface VLAN 11 will not came up.
;-)
;-)
Regards,
Fred Mancen
Fred Mancen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
09-03-2009 06:50 AM
09-03-2009 06:50 AM
Re: Vlan 4800G 24-port
Thanks again Fred_Mancen.I will check.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
09-03-2009 08:10 AM
09-03-2009 08:10 AM
Re: Vlan 4800G 24-port
Until u not connect network device to the switch port with this vlan, state status is DOWN.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP