Comware Based
1748282 Members
4136 Online
108761 Solutions
New Discussion юеВ

What is CLI for Display Switch buffer used (HP5120 Comware 5.20.99)

 
jetsettronn
Occasional Advisor

What is CLI for Display Switch buffer used (HP5120 Comware 5.20.99)

Hi,

I use CLI

<HP>display memory
System Total Memory(bytes): 877773280
Total Used Memory(bytes): 123512556
Used Rate: 14%

But not show buffer using, What is CLI for Comware5.

3 REPLIES 3
parnassus
Honored Contributor

Re: What is CLI for Display Switch buffer used (HP5120 Comware 5.20.99)

Well, the Comware 5 (as running on the HPE 5120 EI) display memory command just displays what is coded to show: memory usage statistics (in detail, as you pointed out: Total System Memory, Total Used Memory and Memory Used Rate).

The Comware 7 (as running on the HPE 5130 EI) display memory offers more informations (with a memory buffers usage reference) compared to the same command ran on Comware 5.

Are you referring to those memory buffers?

Why are you expecting that Comware 5 display memory command shows memory buffer(s) related information as happens in Comware 7?

I fear that there isn't actually a Comware 5 command to show specifically buffer(s) status? ...if any, then what buffers do you exactly mean? do you mean port buffer failures? or log buffer? trap buffer? memory buffers?

So, first, what do you mean when you simply write "buffer"?

The Comware 5 display diagnostic-information command for sure contains more info but I'm not sure that it shows explicitly buffer(s) information other than those reported above (port buffer failures, log buffer, trap buffer).

 

 


I'm not an HPE Employee
Kudos and Accepted Solution banner
jetsettronn
Occasional Advisor

Re: What is CLI for Display Switch buffer used (HP5120 Comware 5.20.99)

]display memory
The statistics about memory is measured in KB:
Slot 1: 
             Total      Used      Free    Shared   Buffers    Cached   FreeRatio
Mem:        903332    323464    579868         0       928    116888       64.3%
-/+ Buffers/Cache:    205648    697684
Swap:           0         0         0

I'm need to know memory buffer using.

parnassus
Honored Contributor

Re: What is CLI for Display Switch buffer used (HP5120 Comware 5.20.99)

Exactly, the one above is the output of Comware 7's display memory command, not of Comware 5.

<system> display memory
The statistics about memory is measured in KB:
Slot 0:
             Total      Used      Free    Shared   Buffers    Cached   FreeRatio
Mem:        507980    154896    353084         0       488     54488       69.5%
-/+ Buffers/Cache:     99920    408060
Swap:           0         0         0

I'm not an HPE Employee
Kudos and Accepted Solution banner