Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

What is command similar to "show running-config all" ?

 
SOLVED
Go to solution
Occasional Contributor

What is command similar to "show running-config all" ?

What is command similar to "show running-config all" ?

am trying to know all running functions and services.

■comware7

HPE FlexFabric 5945 48SFP28 8QSFP28

 

7 REPLIES 7
HPE Pro
Solution

Re: What is command similar to "show running-config all" ?

Hi @Tom18 !

There is no 1:1 match for this command in Comware. You can use "display current-configuration" and "display default-configuration", but it's not the same level of details that you get by Cisco's "show run all"

Maybe this guide will help you to navigate in Comware and make Cisco->Comware knowledge transfer easier - https://community.arubanetworks.com/HigherLogic/System/DownloadDocumentFile.ashx?DocumentFileKey=7eb10b33-891a-4ef0-86d9-1e1c13be4fde

 

I am an HPE employee

Accept or Kudo

Occasional Contributor

Re: What is command similar to "show running-config all" ?

Hi, @Ivan_B .

Thank you a lot!

The guide is helpfull.

Have a great day!

Frequent Advisor

Re: What is command similar to "show running-config all" ?

display current-configuration all

HPE Pro

Re: What is command similar to "show running-config all" ?

Hi @cgu !

I wish that would be so easy, LOL. 

image.png

I am an HPE employee

Accept or Kudo

Honored Contributor

Re: What is command similar to "show running-config all" ?

As usual, Comware rocks!


I'm not an HPE Employee
Kudos and Accepted Solution banner
Frequent Advisor

Re: What is command similar to "show running-config all" ?

OK my bad then, as the "all" keyword is available since quite some time on 5130 and 5510 platforms I expected that it would also exist on 5945.

HPE Pro

Re: What is command similar to "show running-config all" ?

Hi @cgu !

You are right, this 'all' option has been added in release 3207 for 5130 and hopefully will be implemented on all Comware 7-based devices soon or later as I also find it very handy when you need to quickly find out what are the defaults for particular feature. However, so far the majority of CW7 devices still don't have this feature and every time I doubt about default option of a feature I need to check the command reference guide... Hope this will change soon! 

 

I am an HPE employee

Accept or Kudo