- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- assign interface to layer 3 on switch HP Flexfabri...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-28-2018 08:41 AM
11-28-2018 08:41 AM
I want to config static route from switch HP 5700 to switch Cumulus OS but I can not set up ip on interface.
I try to use "port link-mode route" command to change port from layer 2 to layer 3, this command not found on this switch.
I read following document:
https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c04565841
It didn't help me.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-28-2018 09:46 AM
11-28-2018 09:46 AM
SolutionHi Alfred,
5700 doesn't support L3 ports. You may use Switched Virtual Interfaces instead which means to configure an ip address on a VLAN interface like
interface Vlan-interface 10 ip address 10.10.1.1 24
5700 allows for 32 IP addresses and 128 static routes only as HPE regards it as being a L2 switch with lite L3 functions.
Cheers xcver
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-29-2018 07:51 AM
11-29-2018 07:51 AM
Re: assign interface to layer 3 on switch HP Flexfabric 5700
Thanks for your solution.