comware5 <-> comware7 LACP question

[hmju]

Set the comware5 switch and comware7 switch to lacp configuration.

I will connect four UTP cables. Is there anything special about connecting?

Is there anything I need to be careful about?

[akg7]

Hello,

I believe UTP cable is supported on those ports.

All ports should be in auto neg

Thanks!

[hmju]

A5500 (comware5)#4-5510 (comware7)#4 will be linked to UTP 4 cable lacp.

The A5500 (comware5) is rstp and the 5510 (comware7) is pvst.

Do you mind if I do trunk permit all?

[akg7 · Accepted solution]

Hello,

Both side bridge aggegation config should be same.

If you are allowing all vlans then do it on both side.

Thanks!