Comware Based

comware5 <-> comware7 LACP question

 
SOLVED
Go to solution
hmju
Occasional Contributor

comware5 <-> comware7 LACP question

Set the comware5 switch and comware7 switch to lacp configuration.

I will connect four UTP cables. Is there anything special about connecting?

Is there anything I need to be careful about?

3 REPLIES 3
akg7
HPE Pro

Re: comware5 <-> comware7 LACP question

Hello,

I believe UTP cable is supported on those ports.

All ports should be in auto neg

Thanks!

I am an HPE Employee

Accept or Kudo

hmju
Occasional Contributor

Re: comware5 <-> comware7 LACP question

A5500 (comware5)#4-5510 (comware7)#4 will be linked to UTP 4 cable lacp.

The A5500 (comware5) is rstp and the 5510 (comware7) is pvst.

Do you mind if I do trunk permit all?

 

그림1.jpg

akg7
HPE Pro
Solution

Re: comware5 <-> comware7 LACP question

Hello,

Both side bridge aggegation config should be same.

If you are allowing all vlans then do it on both side.

Thanks!

I am an HPE Employee

Accept or Kudo