- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: first configuration switch 4210
Comware Based
1752577
Members
4071
Online
108788
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-05-2009 01:14 AM
08-05-2009 01:14 AM
first configuration switch 4210
Hi all, need some advise and info please, the switch 4210
26 port just arrived at my place and all users had been connected on it but what the first thing i must configure on that switch cause honestly this is the first
time i use switch manageable ?
sorry for this stupid question, need advise please.
Thanks a lot.
26 port just arrived at my place and all users had been connected on it but what the first thing i must configure on that switch cause honestly this is the first
time i use switch manageable ?
sorry for this stupid question, need advise please.
Thanks a lot.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-06-2009 01:42 PM
08-06-2009 01:42 PM
Re: first configuration switch 4210
I usually setup the following:
Give it a STATIC (not DHCP) IP address.
Setup the passwords and change the SNMP community strings away from Public/Private.
Give the device a name.
Turn off STP (spanning tree) if you are sure there is no way to create an accidental "loop" in the network.
That is all you may need. Everything else is to "tweak" the unit.
Good Luck.
Rob.
Give it a STATIC (not DHCP) IP address.
Setup the passwords and change the SNMP community strings away from Public/Private.
Give the device a name.
Turn off STP (spanning tree) if you are sure there is no way to create an accidental "loop" in the network.
That is all you may need. Everything else is to "tweak" the unit.
Good Luck.
Rob.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP