Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

multicast-LAYER2

 
Occasional Contributor

multicast-LAYER2

HI,

 i am having a problem of traffic multicast layer 2 - igmp-snooping

the infrastructure consist of 4 switches- multicast in the same vlan

2 access switches -3com4500 and hpe 5510

access switches connected to distribution switches in bridge aggregation.

on every access and distribution switch i enabled igmp-snooping on the vlan

for example

global 

#
igmp-snooping

 #
vlan 62
igmp-snooping enable

 

no  storm-constrain multicast are configuers on access port and uplink.

still doesnt work any suggestions? am i missing something?

 

thanks,

1 REPLY 1
HPE Pro

Re: multicast-LAYER2

Hello  shuki_miz, 

You may want to check where your querier is and if needed add static router ports towards the multicast source.

Please use the following guide to setup the IGMP snooping:

http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-a00007127en_us-1.pdf

Hope this helps.

 

 

 

I am an HPE Employee

Accept or Kudo