Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

multilink protocol compatibility issue with cisco router and HP MSR3044

 
vivekacme
Occasional Visitor

multilink protocol compatibility issue with cisco router and HP MSR3044

i am not able to configure cisco multilink protocol in hp msr3044 router. i have tried many times to configure it but still physical port is up and protocol is showing down state.
so i just want to know about that there is a serial interface compatibility issue.
if anyone faced same issue earlier kindly repely and share your knowledge.

Find below both router configuration

CISCO 3600 Series configuration.............................................................................................................

interface Multilink10

 ip address 10.0.0.1

255.255.255.252

 ppp multilink

 ppp multilink interleave

 ppp multilink group 73

 ppp multilink fragment delay 10

 no cdp enable

 

interface Serial0/0/0

 description "tes_linkt"

 bandwidth 2048

 no ip address

 encapsulation ppp

 ppp multilink

 ppp multilink group 10

 

HP MSR 3044 Router Configuration,.....................................................................

HP MSR 3044 router

interface MP-group10

ip address 10.0.0.2

 255.255.255.252

ppp account-statistics enable

 

JG737A .........serial card part no hp

HPE MSR 4p Enh Sync/Async Srl SIC Mod

interface Serial1/0

description-test_link

bandwidth 2048

link-protocol ppp

ppp mp MP-group10

 

I have also attached word file to understand network diagram

 

 

1 REPLY 1
akg7
HPE Pro

Re: multilink protocol compatibility issue with cisco router and HP MSR3044

Hi,

This seems to a limitations of the module.

Which firmware you are using?

Advising you to log a case with support so they can check the compatibility.

Thanks!

I am an HPE Employee

Accept or Kudo