- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- stp fast start
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-29-2010 09:09 AM - last edited on 02-16-2014 07:48 PM by Lisa198503
09-29-2010 09:09 AM - last edited on 02-16-2014 07:48 PM by Lisa198503
stp fast start
Hello all,
I have a view 3com 3870 switches with some ports directly connected to an server and some ports connected to other switches, the ports connected to en server (end link) are stp fast start enabled.
Now i have a 3Com SuperStack 4 Switch 5500G-EI, how do I enable stp fast start? or do I have to configure the ports on an other way (differents between a port used for an server or a port used for an switch/hub)?
Kind regards,
Marc Dekker
P.S. This thread has been moved from ProCurve / ProVision-Based to Comware-Based. -HP Forum Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2010 10:18 PM
10-06-2010 10:18 PM
Re: stp fast start
As far as I can judge, command "stp edged-port enable" does this for you in default configuration of 5500G-EI.