HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

sw4800 - Initial Configuration

 
ibarnwell
Occasional Contributor

sw4800 - Initial Configuration

I am trying to connect to the switch using the console port using hyperterminal defaults - 9600 baud, 8 data bits, no parity, 1 stop bit and no flow control but I don't get the CLI prompt so when I type system-view nothing happens.



Any ideas?