Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

topology changes access point linkdown

SOLVED
Go to solution
MSerkowski
Occasional Contributor

topology changes access point linkdown

Hello,

recently we have recieved some topology change messages on our core switch (5900 IRF stack, stp enabled, mode RSTP). 

Logbuffer: MSTP/6/MSTP_NOTIFIED_TC: Instance 0's port Bridge-Aggregation1 was notified of a topology change.


Access switches are 5500-HI IRF stacks (Release 5501P25), with static link-aggregations to the core switch. 

We discovered, every time an access point, that is connected to our 5500-HI access switches goes down, a tc message is displayed. The port where the ap is connected is configured as an stp edge port. 

When displaying stp config for the access point port, the stp edge doesn't seem to work. 

Port Edged :Config=enabled / Active=disabled
Point-to-point :Config=auto / Active=true

 

Port Config:

interface GigabitEthernet2/0/15
port link-mode bridge
port link-type hybrid
port hybrid vlan 2070 2074 2214 tagged
broadcast-suppression pps 3000
undo jumboframe enable
stp edged-port enable

Setting stp point-to-point force false doesn't help.

The  problem also occurs on our aruba 2530-Switches with the same stp config. 

Access Points are WatchGuard AP300/200. 

 

Any ideas?

 

Thank you,

Marlon

1 REPLY
Mike79
Advisor
Solution

Re: topology changes access point linkdown

HI,

You can try both:

undo stp port-log all

undo stp port-log instance 0

Hope it helps

Cheer!

Michal