HPE Community
Operating System - HP-UX
1753406 Members
7372 Online
108793 Solutions
New Discussion юеВ

Upgrade help

 
Thomas Luong
Occasional Contributor

тАО06-14-2000 07:03 AM

тАО06-14-2000 07:03 AM

Upgrade help

I will be upgrading from a K260 to a K360. The upgrade will eliminate HPPB slot 10/4/12, which is currently in use by our controller on the K260.

What are the steps to re-map the address and not lose any of the volume groups?

Note: Running HP-UX 10.20

The controller affected is 1 of 2 attached to an AutoRaid.
0 Kudos
Reply
2 REPLIES 2
Andy Monks
Honored Contributor

тАО06-14-2000 07:06 AM

тАО06-14-2000 07:06 AM

Re: Upgrade help

with the upgrade comes a script that converts the I/O mappings.

procupgrade.k260 (or something like that). it's on a tape/cd thats part of the h/w kit.
0 Kudos
Reply
Patrick Wessel
Honored Contributor

тАО06-14-2000 07:23 AM

тАО06-14-2000 07:23 AM

Re: Upgrade help

Are you sure that you are loosing HP-PB bus slots on an upgrade from K260 to K360? I don't think so...
If you lose a SCSI host bus adapter with a none boot disk you can export the VGs on this disks (or disk arrays) and import them after the upgrade. This is the easiest way
There is no good troubleshooting with bad data
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.