Databases
cancel
Showing results for 
Search instead for 
Did you mean: 

tachyon fibre connected to EMC connectrix

Joseph Hoh
Frequent Advisor

tachyon fibre connected to EMC connectrix

has anyone connected to a EMC connectrix box with HP tachyon card. We cannot get it to work. using the fcmsutil command shows the topology as "in-private-loop". EMC thinks this should be "in-pttopt". Can I change this? what is missing?
thanks
2 REPLIES
Andreas Kromat
Occasional Advisor

Re: tachyon fibre connected to EMC connectrix

Hi Jeff,

be sure that you have the lastest driver release of the tachyon controller.
Look at https://software.hp.com/cgi-bin/swdepot_parser.cgi/cgi/try.pl?productNumber=A5158A

Regards,
Andreas
Ovidiu D. Raita
Valued Contributor

Re: tachyon fibre connected to EMC connectrix

Arbitrated Loop (in_private_loop) was the ONLY FC protocol supported by HP. HP decided a couple of months ago to support Fabric too.

My advise is to ask EMC to set up their ports for Arbitrated Loop. If you uses Fiber Hubs to connect to the EMC don't forget to set them up for Arbitrated Loop too.

This config was tested extensivelly and it works just fine.

Ovidiu
Simple solutions to complex problems