Storage Boards Cleanup
To make it easier to find information about HPE Storage products and solutions, we are doing spring cleaning. This includes consolidation of some older boards, and a simpler structure that more accurately reflects how people use HPE Storage.
Showing results for 
Search instead for 
Did you mean: 

12H Perf.


12H Perf.

Hello Masters,
I have Oracle OLTP Application running on AutoRaid 12H. Following is the output of
# arraydsp -s 12
Array configuration:
Active Hot Spare Desired = ENABLED
Auto Include = ENABLED
Auto Rebuild = ENABLED
Rebuild Priority = HIGH
Capacity Depletion Threshold = 0%
Write Working Set Interval = 8640 seconds
Language = ENGLISH
Log Full Warning = DISABLED
Volume Set Partitioning = DISABLED
Format Pattern Fill = DISABLED
Subsystem Type ID = 12
LUN Creation Limit = 8
Maximum LUN Creation Limit = 8
Array SCSI configuration:
Controller X SCSI Address = 1
Controller Y SCSI Address = 0
Write Cache = ENABLED
Read Cache = DISABLED
SCSI Parity Checking = ENABLED
Terminator Power = ENABLED
Unit Attention = ENABLED
Disable Remote Reset = ENABLED
Secondary Controller Offline = DISABLED
Very Early Busy = DISABLED
Queue Full Threshold = 1952
Maximum Queue Full Threshold = 1952
Simplified Resiliency Setting = HighPerformance
Single Controller Warning = ENABLED
Lock Write Cache On = TRUE
Disable NVRAM on WCE False = FALSE
Disable NVRAM with One Ctrlr = TRUE
Disable NVRAM on UPS absent = FALSE
Force Unit Access Response = 0
Disable Read Hits = FALSE
Resiliency Threshold = 0.
Is any change is required to achieve the optimum performance.

Thanks in advance.
Tobias Hartlieb_1
Occasional Advisor

Re: 12H Perf.


to my knowledge, there is not much to tune on this 12h. You have set already the "Simplified Resilency Setting" to "High Performance".
Free Disk space, however, is a major issue for Performance: The more spare disk space, the more data the array will store in Raid Level 0/1 (i.e. mirror) rather than in Raid level 5, which in turn is much better for performance.



HP Response Center Engineer
Trevor Roddam_1
Valued Contributor

Re: 12H Perf.


The 12H is very particular in regard to the Write Working Set and perf.
You have a 2.4Hr value. This means that there isn't enough space available for writes during the day.

With 12H's it is good to get this value higher to approx 12Hrs.
This means increasing the amount of free space. The only way to do this is to remove LUNs from the 12H. I would have a close look at the performance stats before doing this as there may be some fine tuning to bo done on the computers filesystems first.

Could you let us know:
The OS?
The Filesystem config? IE using striping etc.
Output from:
arraydsp -a [arrayid]
arraydsp -r [stime] [etime] [arrayid]
arraydsp -m [stime] [etime] [arrayid]
logprint -s [stime] -e [etime] -t perf [arrayid]

During normal work hours for a 10Hr period.

stime = start time
etime = end time
arrayid = The array ID

There may be some LVM tuning to be done.
Baldric, I have a plan so cunning you could pin a tail on it and call it a weasle.

Re: 12H Perf.

Hello Trevor,
How Can I change the value ofWrite Working Set to 12Hrs. Pl explain.