Storage Boards Cleanup
To make it easier to find information about HPE Storage products and solutions, we are doing spring cleaning. This includes consolidation of some older boards, and a simpler structure that more accurately reflects how people use HPE Storage.
cancel
Showing results for 
Search instead for 
Did you mean: 

Autoraid 12H

Sanjiv Sharma_1
Honored Contributor

Autoraid 12H

Dear Friends,
We have an autoraid 12H. Recently it was giving trouble like it was reinitialising every 10 minutes.
We found that the X controller was defective.
We have replaced the X controller and the autoraid is working fine. During X controller failure it was working on Y controller.
During the autoraid failure we got a message on the control panel : "Ready
12H_#1"

Even after the replacement of the X controller it is giving the same message.

What does the message( 12H_#1 ) means ?
Our system is working fine.

Thanks in advance.

 

 

P.S,. This thread ahs been moved from Disk to Disk array. - Hp Forum Moderator

Everything is possible
1 REPLY
Bob Inglis
Trusted Contributor

Re: Autoraid 12H

I think, but I'm not positive, that your AutoRaid is displaying it's Alias or assigned name. The command: arraymgr -D would give the array a name which would then be displayed on it's front pannel to make it identifiable. This may have been done by service personell to assist them in identifying which array needed service. Reference: MAN page for arraymgr.
Plan for the future and tomorrow will take care of itself.