Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

BC PAIR only goes to 99%

feibob
Occasional Contributor

BC PAIR only goes to 99%

I am creating a BC of a prod volume to take snapshops off the BC. but when i do a pairdisply to check the business copy to see if it's ready to be split so i can take the snapshot off of it, it says that it's in a PAIR state, but only shows 99% complete. here is the output. Sorry for the formatting..

pairdisplay -IBC20 -g train1grp_BC2 -fc

train1grp_BC2 CU31:97_CU53:25(L)(CL1-E-4, 0, 1-1 )29359 12695.P-VOL PAIR, 99 21285 -
train1grp_BC2 CU31:97_CU53:25(R) (CL3-J-1, 5, 0-0 )29359 21285.S-VOL PAIR, 99 12695 -
train1grp_BC2 CU31:98_CU53:26(L) (CL1-E-4, 0, 2-1 )29359 12696.P-VOL PAIR, 99 21286 -
train1grp_BC2 CU31:98_CU53:26(R) (CL3-J-1, 5, 1-0 )29359 21286.S-VOL PAIR, 99 12696 -
train1grp_BC2 CU31:99_CU53:27(L) (CL1-E-4, 0, 3-1 )29359 12697.P-VOL PAIR, 99 21287 -
train1grp_BC2 CU31:99_CU53:27(R) (CL3-J-1, 5, 2-0 )29359 21287.S-VOL PAIR, 99 12697 -
train1grp_BC2 CU31:9A_CU53:29(L) (CL1-E-4, 0, 4-1 )29359 12698.P-VOL PAIR, 99 21289 -
train1grp_BC2 CU31:9A_CU53:29(R) (CL3-J-1, 5, 4-0 )29359 21289.S-VOL PAIR, 99 12698 -

i have another set where most of the pairs are at 100% but there are a few that show 99%. But yet they are all in a PAIR state.

I have checked to see if i'm hitting my limit in BC licenses, and i'm only about half way there.

Is this normal?
3 REPLIES
Bill Rothanburg
Trusted Contributor

Re: BC PAIR only goes to 99%

This is normal if the volumes in question are active. The key is that they are in the PAIR state.
feibob
Occasional Contributor

Re: BC PAIR only goes to 99%

Thanks! That's what i figured, but i wanted to make sure.

Thanks again!
feibob
Occasional Contributor

Re: BC PAIR only goes to 99%

Bill answered my question.