Brocade Sikworm 2800

[SOSS Support]

I am looking any standard and/or recommendation on
how to setup a Brocade Silkworm 2800 fiber switch for
full fabric O.S. support. I have read the manual and
found that there a lot a parameters to setup, are
they all supported as there are no SAN standards as of
yet. Any recommendation would be appreciated.

[Mark van Silfhout · Accepted solution]

Hello,

The Brocade 2800 is by default configured for full fabric. But firmware revision 2.1.9f is highly recommended.
Also be sure that if you have A5158A FC cards, you need the B.11.00.05 version of the Tachyon driver.

Regards,

Mark

[JD_3]

..actually for your configuration we will need to have more info...Lun Masking, zoning....
Full switched fabric...
JD