HPE Community
Disk Enclosures
1752688 Members
5244 Online
108789 Solutions
New Discussion

Command to check BCV configurations

 
manoj_pu
Regular Advisor

‎11-14-2007 04:46 AM

‎11-14-2007 04:46 AM

Command to check BCV configurations

Hi All,

We have hp-ux 11i servers connected with xp256 disk arrays. BCVs and CA is configured for the data volume backup.

I am new to this kind of setup. I want to know how BCVs are configured between hp systems.

Is there any command to check this configuration?
Could any one help on this?

Thanks & regards
Manoj
Leave with out tense and try best you gets result
0 Kudos
Reply
1 REPLY 1
Ivan Ferreira
Honored Contributor

‎11-14-2007 05:15 AM

‎11-14-2007 05:15 AM

Re: Command to check BCV configurations

Go to the XP documentation page. You can use the WEB GUI or the CCI to display configuration. To use CCI/CLI, you need to configure some files (horcmX.conf) in a host with access to a LUN enabled as "command device".

Then you can use pairdisplay, pairmon, raiscan, etc commands to get information about your configuration.
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.