- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Configuring MSA20 connected to DL380 G3
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-30-2013 05:53 AM - edited 01-30-2013 01:33 PM
01-30-2013 05:53 AM - edited 01-30-2013 01:33 PM
Configuring MSA20 connected to DL380 G3
Hi,
I am trying to configure an MSA20 connected to the DL380 G3 via the on board 5i raid controllers external U320 port, I can see the MSA20 in the ACU but am unable to perform any tasks as the ACU hangs.
ive updated all drivers for 5i and MSA20 and installed latest ACU, versions shown below:
O/S is server 2003SBS
Firmware for Smart Aray 5i is Rev B, v2.76 MSA20 = unknown
ACU version= v9.30.15.0
i notice in HP specs that the 5i isn't shown as supported so suspect this may be down to compatibility with the 5i, do i need to install a second raid adapter if so which is best to co-exist with the 5i?
Any advice much appreciated!!
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-21-2013 05:10 PM
02-21-2013 05:10 PM
Re: Configuring MSA20 connected to DL380 G3
This could be an issue with the OS. What you can try is, you can configured the array in BIOS, or boot the server using the smart start CD, and then configure array.
Regards,
Proliant Watch