HPE Community
Disk Enclosures
1753521 Members
5157 Online
108795 Solutions
New Discussion

Re: Disk System 2300 in full bus and 2 hosts

 
ahpux
Occasional Contributor

‎11-11-2004 04:48 AM

‎11-11-2004 04:48 AM

Disk System 2300 in full bus and 2 hosts

I am installing a disk system 2300 with 2 BCCs, 9 hard disks, in full bus mode so that 2 hosts can access it. Host A's HBA is having scsi id as 7 and Host B's HBA is having scsi id as 13. The connection is as follows:
Host A's HBA to BCC1 port A. BCC1 port B to BCC2's port A. BCC2's port B to Host B's HBA.
Presently both the systems fail to boot and report "software Failure" while the PDC is getting loaded.
Has anybody configured DS2300 in full bus with 2 hosts?
0 Kudos
Reply
1 REPLY 1
Zygmunt Krawczyk
Honored Contributor

‎11-11-2004 05:31 AM

‎11-11-2004 05:31 AM

Re: Disk System 2300 in full bus and 2 hosts

You should set scsi id to 6 at host's B HBA (not 13).

Regards,
Zygmunt
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.