- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Re: Drive indicator not showing in ACU
Disk Enclosures
1753605
Members
6182
Online
108797
Solutions
Forums
Categories
Company
Local Language
юдл
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
юдл
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО02-07-2001 04:00 PM
тАО02-07-2001 04:00 PM
Drive indicator not showing in ACU
I am building a new ML 370 with a SA431. I have 3 - 18.2 GB hot-plug drives in a RAID 5 configuration. When I run the ACU I see all three drives, however when I select individual physical drives I do not see the online status or the drive failure lights on the drive in slot 0. Slots 1 and 2 correctly display all three lights. Slot 0 only shows the Drive access light. I have tried another new 18.2 gig drive in the same slot with the exact same results. I am concerned that in case of failure, the drive failure indicator will not light. The only modification I have made to the server is updating the server firmware to 4.07A. Any reasons for this behavior? How can I fix it?
Thanks,
Dan
Thanks,
Dan
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО02-08-2001 04:00 PM
тАО02-08-2001 04:00 PM
Re: Drive indicator not showing in ACU
Apparently I was shipped a couple of bad drives. I swapped out the bad drives for another couple I had purchased and everything's working great.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО04-03-2001 04:00 PM
тАО04-03-2001 04:00 PM
Re: Drive indicator not showing in ACU
Good job of troubleshooting ...
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP