HPE Community
Disk Enclosures
1752492 Members
5468 Online
108788 Solutions
New Discussion юеВ

Re: EMS is not reporting when there is power failure to disk array

 
aaa_37
Occasional Contributor

тАО05-22-2002 03:47 AM

тАО05-22-2002 03:47 AM

EMS is not reporting when there is power failure to disk array

Hi,

Anybody know why EMS is not reporting any alarm when there is power failure to "SureStore E" disk array. STM version I am using is A30.00. Let me know what may be the problem

Thanks in advance
0 Kudos
Reply
2 REPLIES 2
Hartmut Lang
Trusted Contributor

тАО05-22-2002 04:58 AM

тАО05-22-2002 04:58 AM

Re: EMS is not reporting when there is power failure to disk array

Make sure your "ARMServer" and "arraymond" processes are running.

Hartmut
0 Kudos
Reply
Robert_Jewell
Honored Contributor

тАО05-22-2002 07:44 AM

тАО05-22-2002 07:44 AM

Re: EMS is not reporting when there is power failure to disk array

You could also check out the EMS configuration:

Run the command to start the configuration tool:

# /etc/opt/resmon/lbin/monconfig

From there you can go through and see what monitors are configured for what.

-Bob
----------------
Was this helpful? Like this post by giving me a thumbs up below!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.