- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- EVA 8000 Unmappable Hardware,...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-26-2012 06:43 AM
10-26-2012 06:43 AM
Hello Everyone,
I have an EVA8000 2C18D. HDDs are all FATA and placed in EVA based on EVA Disk Placement document. Command view version is v9.03.00.100811 and XCS Version is 6.25.
All enclosures have their own ID which is shown on EMU.
Problems are:
1- All the HDDs are shown under unmappable hardware folder.
2- Following event repeats every minutes in my controller event log:
event code: 06410017 The device loop configuration has changed on a HSV210 controller's Fiber Channel port.
Screen shots of CV & Even log are attached. Please infrom attanetion on the Contollers related to link failure on 2 of host ports which are not connected to SAN Switch.
Regards,
Delrish
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-27-2012 03:10 AM
10-27-2012 03:10 AM
Re: EVA 8000 Unmappable Hardware,...
Hi,
if you will have two ports unconnected you should put a loopback device in there. If it's not in production yet this increases the ways available to you for troubleshooting - like disconnect a shelf/loop and see if problem disappears. But would be of course good to try to figure out which loop the problem might be on.
Logs are not attached (I cannot parse them).
No CV 10?
Unmappable hardware - check back of the enclosure for errors on the EMU/CAB and device port connections.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-27-2012 03:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-27-2012 04:02 AM
10-27-2012 04:02 AM