EVA4400 shutdown procedure ?

[Uwe Zessin]

Ah, I think that explains it...

You first wrote you shutdown via CV, but if you did not run with the latest XCS, you did not use CV on the WOCP - just the WOCP function.

[damiri]

So what is then correct procedure/tool for shutdown ?

[Víctor Cespón]

It can be shutdown from Command View or from the WOCP. From the WOCP, if the controllers have firmware 09004000 or 09003000, it does not power off the disk enclosures. This is a known issue and it's documented in HP.

[damiri]

Ok, thank you again for support ...

[damiri]

Hello, now using WOCP can powerdown controllers and disk enclosures. However, I am expeirencing number of issues with WOCP. Actually it is not usable at all. Too slow, can't do anything on EVA4400. Again, do you have that kind of expeirence ? I am running CV 8.1 and latest firmware for EVA4400...

[Víctor Cespón]

Firmware 09006000 needs WOCP firmware 0001.0020 or 0001.1000.
Do you have them installed?
If yes, try to reset the onboard administrator, or reseat it.

[Víctor Cespón]

The management module, sorry.

I'm dealing with a c-Class blades case and had the OA on my mind.

[damiri]

I think I have mmp-0001.1000-000117R on it. However I have to load it up with CV over FC to access it again. Is this version Ok to load ? I guess this is latest one?

[Uwe Zessin]

That is the first version which includes CV-EVA and is fine - all previous versions did only include the WOCP functionality. As CV-EVA runs on port 2372, it has now moved to port 2373

[damiri]

WOCP is on 2373 but when I run CV from WOCP, it goes to 2372 port and I can't do anything with it ...