Storage Boards Cleanup
To make it easier to find information about HPE Storage products and solutions, we are doing spring cleaning. This includes consolidation of some older boards, and a simpler structure that more accurately reflects how people use HPE Storage.
Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

!!! Error in system !!! Failed to configure.

om_1
Occasional Visitor

!!! Error in system !!! Failed to configure.

I get that message in "netraid assistant" when I try to save new config : raid 5 spanned array in Ms clustered environment .
Firmware version?

thanks a lot.
2 REPLIES
Marco Hogeveen
Honored Contributor

Re: !!! Error in system !!! Failed to configure.

Could you privide a little more detail about your configuration?
What Netserver, what Netraid, NT4 or windows 2000?
How is your shared storage configured? (how many disks, how are the other logical drives configured)
What??s the firmware of the Netraid?
What happens if you try to create a non-spanned RAID5?
Or a spanned RAID1 (RAID10)?

Marco.
Enes Dizdarevic
Honored Contributor

Re: !!! Error in system !!! Failed to configure.

Two years ago I had the same error trying to configure spanned raid1 in cluster enviroment. The workaround was to load non-cluster version of netraid firmware create spanned raid1 and load cluster version of firmware again.
Few weeks ago I create spanned array1 in cluster enviroment without any problems. (I do not recall version of firmware in this two cases.) I think the same situation is for spanned raid5. So, newer version of clustered firmware could solve your problem. If not use the same workaround.