cancel
Showing results for 
Search instead for 
Did you mean: 

FC60 Error

FC60 Error

Hi,

Can anybody help me out finding for a solution with the problem stated below:

I have an FC60 connected to a rp5470 with 2 x SC10 disk enclosure (2x36GB HDD).

However, with a human error, one of the SCSI connection to the SC10 was pulled out, and when I tried to reconnect and watch on the console, I found out an error.

1 4:0 Flt--67 HP 36.4G ST336753LC HPC3 3HX1BYBL 33.9gb
1 4:1 Flt--67 HP 36.4G ST336753LC HPC3 3HX1C1T7 33.9gb
1 4:2 Flt--67 HP 36.4G ST336753LC HPC3 3HX1CD0L 33.9gb
1 4:3 Flt--67 HP 36.4G ST336753LC HPC3 3HX1C3G4 33.9gb
1 4:4 Flt--67 HP 36.4G ST336752LC HP03 3ET0YWPR 33.9gb


Please help.

regards,
Marv's
2 REPLIES
Mike Shilladay
Esteemed Contributor

Re: FC60 Error

Hi Marvin,

May sound obvious, but did you connect it into the same SCSI port that it was originally attached ? (This matters in case of Dual attach/Single attach to the SC10)

Mike
tkc
Esteemed Contributor

Re: FC60 Error

ok, since you only have 2 x SC10, they should be set up as split-bus configuration. all the dip switches of both SC10 should be set to '0' i.e. '00000'.

you probably want to tell us the settings of the rotary switch in each BCC of the SC10.
also the current scsi cabling of each BCC to the FC60 controller.