Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

FC60 controller in Passive mode

Nelson Broskey_2
Occasional Visitor

FC60 controller in Passive mode

In case anyone has reconfigured or otherwise confused their FC60 array (A5277A
Surestore E Disk Array) such that one or both of its controllers have gone
"passive" there is an undocumented (at least so far) command to reset them to
"active" state. It is:

ammgr -c AA
1 REPLY
Nelson Broskey_2
Occasional Visitor

Re: FC60 controller in Passive mode

OOPS!
That command needs the array id after it as usual. not sure why "arrayid"
surrounded by arrows as used in the users guide did not post on the first
message...let me use parenthesis instead:

ammgr -c AA (arrayid)