Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

Force Unit Access

Force Unit Access

Can someone please tell me how to change "Force Unit Access Response" in the 12H autoraid configuration? It is set to 0 and I want to change it to 2. I have the Sys Admin manual but it isn't helping me regarding this particular setting. I have tried changing the Simplified Resiliency but this does not affect the Force Unit Access setting.
7 REPLIES
David Navarro
Respected Contributor

Re: Force Unit Access

I have seen in admin manual that this parameter takes effect when write cache is enabled. Do you have warite cache enabled?.

Re: Force Unit Access

Yes, write cache is enabled. I thought that would change it also but it didn't.
David Navarro
Respected Contributor

Re: Force Unit Access

Hi, I see data resiliency mode in manual. Try to change it with arraymgr command, and you can see if that value has been change or not.

Re: Force Unit Access

I changed the resiliency to Secure, High Performance, etc but nothing is changing the Force Unit Access.
David Navarro
Respected Contributor

Re: Force Unit Access

Last Idea I have is check your firmware version, maybe is an older one. I don't know which version are actually running in that boxes.

Re: Force Unit Access

Firmware is HP62
David Navarro
Respected Contributor

Re: Force Unit Access

HI. That is the last F/W release in HP web. Is dated on Oct-2000.